Mountain Bike Reviews Forum banner

Magura Vyron rebuild

10K views 7 replies 7 participants last post by  7four8  
#1 ·
I am going to try and service my Magura dropper seatpost, but I was unable to find schematics or instructions online for it. Has anyone done it before and how?

Also if anyone has done this, maybe you can help. I am trying to make the stroke of the dropper slightly less. With the post as low as it will go in my frame, it is still about 1 cm too high, so I am trying to find a way to make it a little shorter. I figured when I have it apart for a rebuild I could add some spacers at the bottom of the shaft so it will top out sooner.
 
#2 ·
I would be equally interested to understand how to shorten the stroke of the Vyron.

Magura is now shipping 100mm and 125mm versions of the Vyron. The photos I've seen look like the bottom/outer tube is the same length on all versions, and only the extension of the inner tube is different between models. This implies that an aftermarket/DIY method may be viable.