Mountain Bike Reviews Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
474 Posts
Discussion Starter · #1 ·
I'm trying to piece together a DIY light with 4 XPG optics. I have a few questions on ordering. Are the Tina XPG optics for a round 10mm PCB? Is the part number for ordering the XPG's with a 10mm PCB 10SRO?

Do you guys have any ideas on housings? I'll be running these at 1A. Thanks!
 

·
recognize the slowness
Joined
·
483 Posts
I believe there is a recent thread on peoples feelings and opinions of 'all' current XPG optics. Search for that if you don't get much response...

Housings are all over the map also. Are some premade ones around if you search for that too.

Hope that helps.

JB
 

·
Registered
Joined
·
190 Posts
I belive Tina optics would best sit on 20mm star PCB, but I believe Cutter's 10mm PCB (both square and round) would be OK as well. And as far as coding of 10 mm round PCB goes - yes, 10SRO is the correct ordering code for those.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top