[jimmy]

I picked up an XCc frame, want to move my parts over to it from my 2005 Alu XC. Will all the parts move over or have the specs changed? Thanks.

 

[VERT1]

Should be a straight swap, seat tubes are the same across the whole SC range and your headset will be the same too (i dont think the xcc is tapered)

 

[a1m80t]

Not quite, I"m pretty sure:

The xcC uses a bottom swing FD and a 73mm BB.

My 2007 SC uses top swing FD and 68mm BB.

 

[hkenshin]

Not quite, I"m pretty sure:

The xcC uses a bottom swing FD and a 73mm BB.

My 2007 SC uses top swing FD and 68mm BB.

When I swapped over the a shimano external bb from a blur classic to an LT2, all I had to do was use 1 less spacers (on the non drive side I think). Not a big deal, there are notes on their website somewhere about which spacers to use on which side to get the proper chain line.. Not sure about the FD tho, since I don't run one any more.

 

[PainkillerSPE]

You will need a new rear shock as well.

 

[jimmy]

Not quite, I"m pretty sure:

The xcC uses a bottom swing FD and a 73mm BB.

My 2007 SC uses top swing FD and 68mm BB.

I am using XTR Cranks, the 960 model year...I have no idea if its 68 or 73. Are all cranks the same?

 

[hkenshin]

I am using XTR Cranks, the 960 model year...I have no idea if its 68 or 73. Are all cranks the same?

Cranks will work fine, it's the bb spacers you need to change:

http://www.parktool.com/blog/repair-help/external-bearing-crank-systems-hollowtech-ii-megaexo-giga-x-pipe-x-type-campagnolo-ultra-torque#shimano

Like I said before, seems like you just need 1 2.5mm spacer on the drive side and no other spacers versus what you have now.

 

[jimmy]

Thx!

Tahnks:thumbsup:

 

[jimmy]

correct

Not quite, I"m pretty sure:

The xcC uses a bottom swing FD and a 73mm BB.

My 2007 SC uses top swing FD and 68mm BB.

Per the Golden Bike Shop, who is doing the job for me, I need a new FD.