Mountain Bike Reviews Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
538 Posts
Discussion Starter #1
Anyone know where or how to get new rear bushing for a Voodoo Canzo? I have tried contacting Voodoo a number of times and have not heard a word back. Love the bike and would like to get it going again.
 

·
Registered
Joined
·
538 Posts
Discussion Starter #3
I am actually looking for information on the bushing where the seat stay and chain stays meet.
 

·
Trail Tire TV on blogger
Joined
·
4,237 Posts
try http://www.enduroforkseals.com - (realworldcycling, same place) they have all kinds of bearing and can get you what you need...

If you look on the black seal there should be a # there you can use to reference what you need for a replacement.

you will need a press to get them out and new ones back in.

other option is if they aren't that bad you can just clean them and re-grease.. take a pick or a pin and just softly peel back the seal from the outer edge, I use a thin oil over a degreaser to clean (I use tri-flow) hit it with a air blast then pack in grease. reassemble and go for a few rides. I usually go back and pack it with more grease after a few rides to make sure it's really loaded and everything is covered...
 

·
San Diego County
Joined
·
1,475 Posts
He needs the little clear plastic ones. biggearss, how have you tried to contact Voodoo? They always answered me via email.
 

·
Registered
Joined
·
538 Posts
Discussion Starter #8
I have tried email. even from two different accounts thinking one may have gone to spam. They were always good about answering when I first bought the bike.

I have attached a few pictures showing the pivot that needs repair and the part I am looking for.
 

Attachments

1 - 12 of 12 Posts
Top