Mountain Bike Reviews Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,095 Posts
Discussion Starter · #1 ·
I've added the exact same amount of stans to my front and rear wheels. The front is still all liquid and sloshes nicely if I shake it. The rear is all pebbles and I can't even tell if there's liquid because it sounds like a maraca. How would this happen?

They are 2.25 Nobby nics installed in Jan and the bike sat through the winter. They stayed sealed but were soft. I added 3 oz of stans to each and noticed some pebbles at that point. I rode them twice and now I think the pebbles are worse now but not sure.

Is something wrong in the rear? Seems odd right?
 

·
Registered
Joined
·
369 Posts
Are the nics using diff. rubber compounds? Otherwise was one wheel closer to a heat source (water heater etc.)?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top