Mountain Bike Reviews Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
Any help would be appreciated... I was installing a Sram Level TL brake on the fork of a new bike. My understanding was it was prebled. After removing the plastic guard between the pads and installing the front wheel I clamped down on the lever and immediately there was the sound of a sharp loss of air and oil shot out of the middle of the brake body. The piston does not engage and every time I press the lever oil seeps out of the brake body at the same spot it shot out.


Sent from my iPhone using Tapatalk
 

·
Magically Delicious
Joined
·
9,822 Posts
After removing the plastic guard between the pads and installing the front wheel I clamped down on the lever and immediately there was the sound of a sharp loss of air and oil shot out of the middle of the brake body.
Just to be sure....

These brakes were mounted on the fork and the front wheel and rotor was installed?
 
1 - 4 of 4 Posts
Top