[CMinSC]

I just sent my shock out for service. The shop is going to put new DU bushings in but I noticed the mounting hardware has some surface wear. The surface feels smooth to the touch but obviously coating is obviously worn off. Would you replace these?

 

[MudderNutter]

I'd keep using it, but I'm no rocket scientist

 

[Jayem]

Those do wear out. It takes longer than the bushings, but I've had to replace them. If there is any play in the linkage/eyelets of the shock when mounted up, then replace for sure.

 

[dir-T]

I wouldn't worry about it at all.

 

[CLDSDL43]

Unless it causes "play/loose" pivot I would think all good.