Mountain Bike Reviews Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
159 Posts
Discussion Starter · #1 ·
OK, So heres the deal, recently I installed a set of XTR Rapidfire shifters on my bike. After everything was finished I began to realize the cable housing in front of my handlebars is super long.:madman: My question is, Is there anyway I can cut the end of the housing to shorten it without screwing it up where it enters the little housing slot on the frame. I dont think the long housing affects performance in any way, its just that its annoying.

Thanks in advance
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top