Can any one tell me the type of thread for a Presta valve cap.
It appears to be a very coarse thread no taper (proably metric). Any ideas.
It would also be the internal thread for a presta/schrader adaptor (will use one but I like clean piping).
The end result is to be a lubricator to add Stans to my mavic UST without breaking the bead.
I appear to be using Stan's at a rate of 1 oz/month. I think this is actually used up in sealing punctures.
I ride a lot of rocks (scree) this seems to cause little cuts by the outside knobs on a Panaracer Fire XC.
What is the best tire for SCREE
It appears to be a very coarse thread no taper (proably metric). Any ideas.
It would also be the internal thread for a presta/schrader adaptor (will use one but I like clean piping).
The end result is to be a lubricator to add Stans to my mavic UST without breaking the bead.
I appear to be using Stan's at a rate of 1 oz/month. I think this is actually used up in sealing punctures.
I ride a lot of rocks (scree) this seems to cause little cuts by the outside knobs on a Panaracer Fire XC.
What is the best tire for SCREE
