Mountain Bike Reviews Forum banner
1 - 3 of 3 Posts

·
carpe mañana
Joined
·
7,308 Posts
Both of them? You could try to drill two small holes opposite of each other and use a pin spanner.

_MK
 

·
Registered
Joined
·
380 Posts
I had this problem and used the cutting wheel on my dremel tool. I carefully put cuts in the top cap and then pryed and cut some more. It took awhile but was able to push the axel out the other side.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top