[TheDon]

I asked this in the Specialized forum, but had no replies.

I just bought a Roco TST-r and need a mounting pin for it to attach on to my 2005 S-works Enduro 150

Does anyone know what size I need to get?

The shop I ordered it from said they didn't have any, so I need to order from somewhere.

 

[bear]

The Roco shox use the same reducer hardware and bushings as Fox, so if you took a Fox off your Enduro you can use the same hardware for your Roco.

If not, then you need to measure the width between the mount points to find out the overall width, and the size of the bolt that passes through (usually 6.x or 8.x mm) and then you can buy reducers for Fox or Roco to size to make it work.

The DU bushing inside the shock eyelets are standard 1/2" IIRC.

 

[TheDon]

ok.

I was thinking of hanging on to the DHXAir and swapping over between shocks depending on the ride I will be doing.

So getting the reducer pin out every time will be a pain.
I will measure and talk to a shop.

 

[mtnbiker4life]

So getting the reducer pin out every time will be a pain.

Not to mention it significantly reduces the life of the DU Bushings everytime you remove the spacers/reducers.