[helimech]

Does anybody know where to get new shock rear reducer bushings, not the DU bush the steel one where your mount bolt goes thru. Thanks, later.

 

[zahgurim]

I think contacting Sinister directly would be your best bet.

 

[A. Nony Moose]

Sinister might be able to help you, depending on what shock you're using. Your best bet is to go thru the shock manufacturer... you just need to know the bolt size (8mm on the R9) and the overall spacing width at the mounts. (i forget what that is exactly)

 

[helimech]

Ya thanks guys, I've checked with sinister and they have none in stock. Marzo, Progressive and fox have none either. So I've taken mine to a local macine shop to get some made. The size is 8mm / 39mm. I was hoping to get some that were allready made up instead of going to the machine shop to make some (more $$). Thanks, later.

 

[JRA925]

Contact btf95 here on the mtbr forum, might be able to help out.

 

[SuspectDevice]

The body end is 40mm not 39mm. Any shop could order you one. Have them order RS8358 from QBP. Should be about $20 at most.