[slideways666]

Just picked up a new monarch rt3 from push and looking to install this badboy... I was looking for the torque specs and found this posted on the ibis site.. "All forward shock mount and pin bolts: 4 Nm (3 ft·lbs) with blue Loctite"..

So 4Nm used for both the front and rear bolts?(just making sure im reading this right).. If im using stock bolts-- id assume ibis used locktite-- so would i need to reapply it or is the already coated stock bolts fine how they are?

 

[hanssc]

Just picked up a new monarch rt3 from push and looking to install this badboy... I was looking for the torque specs and found this posted on the ibis site.. "All forward shock mount and pin bolts: 4 Nm (3 ft·lbs) with blue Loctite"..

So 4Nm used for both the front and rear bolts?(just making sure im reading this right).. If im using stock bolts-- id assume ibis used locktite-- so would i need to reapply it or is the already coated stock bolts fine how they are?

Rear shock bolt 6 N·m (4.5 ft·lbs) with grease for a SS bolt and anti-seize for a Ti one.

Cheers!

H