Mountain Bike Reviews Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
429 Posts
Discussion Starter · #1 ·
I just got a new raceface ride xc crank. The thing is the left arm is getting loose once or twise each ride. I use the big hex to make it tight but again it get lose. I dont want to over torque it cause Im afraid to mess averything. What is the problem?, What do I have to do?:(
 

·
Old man on a bike
Joined
·
12,395 Posts
Why would over-tightening (i.e. more than required as you last post said) the crankbolt be a raceface crank problem? Have you checked the condition of the splines on the bb axle and cranks?
 

·
Old man on a bike
Joined
·
12,395 Posts
You're looking at the splines, not me, what do you see? Any obvious deformation of the splines/interfaces? If you don't see any I'd torque it to spec and see what happens personally. You using a torque wrench?
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top