Mountain Bike Reviews Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
45 Posts
Hammer-time!

I just removed the press fit 30 bearings from my Scalpel (older 29 carbon).

I used the Park tool headset remover on the non-drive side, and then the park tool bbt30-4 on the drive side.

It took a hell of a lot of hammering, with the frame jammed up against wall, cushioned with some old carpet. I gave up for a hour, then went back. The drive side with the longer sleeve was hardest to get off.

https://www.parktool.com/product/bottom-bracket-bearing-tool-set-bbt-30-4
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top