Mountain Bike Reviews Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
Hey everyone,

I pulled an old bike frame out of the trash pile and am installing a new bottom bracket for the one piece crank. The goal is a single speed.

here is the part:


My question is this...what is the large washer at the bottom leftfor? Is it merely a spacer, and where does it go?

I was told to install it how it came out of the box...but I can't remember how the washer was packed inside the box.

all help is appreciated.
 

·
Registered
Joined
·
51 Posts
Discussion Starter · #4 ·
well i already did install it without using the washer...and it seems to work fine... lol

but i'm just nervous knowing I had an extra part.

I've thought about getting the conversion for 3 piece cranks...but this is an extremely low budget, so I"m keeping the one piece...if I get more into things I would probably end up going the 3 piece way...
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top