Mountain Bike Reviews Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
126 Posts
Discussion Starter · #1 ·
I adjusted the angle of my seat this morning and tightened the bolt to what I thought tight enough with a hex wrench. While riding a couple hours later, the seatpost clamp came loose twice. Perhaps I should have used a torque wrench to tighten. Does anybody know the recommended torque for a C3 seatpost? While I'm at it, I'm expecting a new handlebar for the holidays, so I may as well inquire about the recommended torque for a Headshock stem. I have a 07 F4, if that helps identify the specific stem. Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top