Mountain Bike Reviews Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
89 Posts
Discussion Starter · #1 ·
I just today got my first set of ODI's and after getting the grips installed on my bar, I went to put the barcap on, but they won't fit. I have the Titec El Norte II bar, which seems to be very thick. Should I just ride without the barcaps? It just seems wierd to see the hole in the side of my bar.
 

·
Registered
Joined
·
5,261 Posts
never ride without an end cap, with enough force an un-capped bar can go right through someone.

Either file down the the part of the cap thats interfering, or find a cap that'll fit.
 

·
Registered
Joined
·
1,600 Posts
zedro said:
never ride without an end cap, with enough force an un-capped bar can go right through someone.

Either file down the the part of the cap thats interfering, or find a cap that'll fit.
if it barely dont fit, then hold with clamp and use sandpaper

could take while but result will be smooth
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top