Mountain Bike Reviews Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
Hey, I just received an XTS Moto i purchased off ebay and the wheels were not assembled so i tried to put them on. I am usually very good with this but not with these new disc brakes, im new to them. When i first tried to but the disc in the brake, the gap was to small, so i tried to push them open a bit until it was ok. Then i put the wheel on and the disc in the brake...but the wheels both have drag. How can i adjust this? :confused:
 

·
Meh.
Joined
·
17,508 Posts
Loosen the two bolts that fasten the caliper to the adapter. Squeeze and hold the lever, now retighten the two bolts equally little by little.
 
1 - 2 of 2 Posts
Top