Mountain Bike Reviews Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
1,124 Posts
Discussion Starter · #1 ·
On my last fatbike I used a 3mm offset sprocket with good results. I have a new bike (also 197 rear end) and I'm using Race Face Turbine cranks. The front sprocket (1x) and the alignment with the rear 50t sprocket look WAY off. It's a LOT of cross over. Anyone run a non-boost 6mm chainring to address this? I have the chain stay sprocket clearance and have already shifted the BB to the left using the washers.

Thanks!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top