[Bodhi_1]

So I'm trying to adjust a front derailleur. I've watched some youtube videos and understand that there are some screws to do like a micro adjustment on it and I've tried it, but it's not working.


Whats happening is, when I shift up to the high sprocket it wants to push the chain past that sprocket. When I adjust those little screws slightly it to where it fits on the big sprocket, it then wants to push the chain off of the bottom sprocket when I shift down or it will completely skips the middle sprocket.

Any suggestions would help.

Thanks for your time.

 

[wschruba]

Read this. It sounds like you are fighting improper limit setup as well as improper cable tension.

 

[Bodhi_1]

Read this. It sounds like you are fighting improper limit setup as well as improper cable tension.

WOW, that is exactly what I needed. I'm going to go try these instructions and see if it resolves my problem. I wish I knew this was out there already. Thanks for pointing me in the right direction.