Mountain Bike Reviews Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I've run across a problem with some forks and wanted to know if anyone has had similar problems. I've noticed on some forks (currently a RS Duke XC) when you corner hard, the rotor will rub. I assume this is flex in the fork/front hub. I am able to make it a little better by tightening the front skewer super tight, but it will still rub a bit. Has anyone else had a similar problem and/or have a solution?

Please note that this is not the same issue as the rotor rubbing after you remove and reinstall the wheel. I can see a nice gap on both sides of the rotor when the bike is stationary - the rubbing will only happen when you corner hard.

Thanks
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top