Mountain Bike Reviews Forum banner
1 - 20 of 23 Posts

·
Registered
Joined
·
1,421 Posts
Discussion Starter · #1 ·
just another project to kill some time

remove rotors with a t25 torx

clean with rubbing alcohol, prep is key

mask off brake track and mounting holes

oops old can of white paint is no good

time for a trip, got some safety yellow

elaborate weather guard and wire setup. spray light coats and alternate strokes for each coat. i wait 5 mins between each coat. light spots are ok just remember light coats to avoid drips

drying, will add a few more coats later

remove tape, i was more concerned with masking off the backside of the mounting holes because i did not want any interference with the mounting.

inspecting the goods

put the screws back in

finished

 

·
Registered
Joined
·
353 Posts
I have the same frame and I love it! I've never seen a seat mount like that - what is it called?

I might go the other direction with my rotors and paint them black. I plan to black out my entire bike at some point and I might as well start with the rotors.

Nice work!
 

·
Registered
Joined
·
1,188 Posts
factory paint

I just installed a Rockshox Pike 454 with 20 mm thru axle. so I had to built a new front wheel. I also replace the rotor to fit the new hub. The Frame KHS AM2000, wheels Mavic D 321 and rotor XTR 8 " center lock are all factory painted semi flat gun metal grey.
 

Attachments

1 - 20 of 23 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top