Mountain Bike Reviews Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
556 Posts
Discussion Starter · #1 ·
There are two small screws on the head of the reservoir. What do they do? I noticed that mine are both loose, so I snugged then up but that prevented the compression lever from moving so I backed them both off about a quarter of a turn.

Toy Carmine Black Personal protective equipment Motorcycle accessories
 

·
Registered
Joined
·
556 Posts
Discussion Starter · #4 ·
I looked at that. I don't see anywhere that references them.

I did happen to get a response from somewhere else though....

Those two set screws you can see are the locator pin and the detent ball for the compression lever. If you fully tighten them they will prevent the lever from moving so they are supposed to be about 1/4 turn back from bottomed out.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top