Mountain Bike Reviews Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
449 Posts
Discussion Starter · #1 ·
I have an old kalloy SP-248 seatpost that I need to replace. This is a single bolt post that arcs back at the rear. I want to measure the setback because I need to get a post that has at least the same amount if not a little more setback. I currently have my saddle pushed as far rearward as it can go -- but a few more millimeters would help. Do I just measure from the centerline of the mainpost to the centline of where the seat bolt goes through the arc'ed slot? If anyone has the model of post I mentioned above -- I would appreciate it if you could measure your posts setback so I can compare my measurement.

Thanks
Ed
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top