Mountain Bike Reviews Forum banner
1 - 2 of 2 Posts

·
Str8stunna
Joined
·
47 Posts
Discussion Starter · #1 ·
I recently bought another bike with a Marz 55R on it with a 20mm axle quick release setup. This is the one that you turn until it clicks and thats the correct torque setting....my question is at the opposite end of that is a small piece that sticks out and if you dont push it aside the QR wont back out, it supposed to catch on the raise portion and stop it from backing out. The fork I have isnt catching when its being back out. Is there anyway to adjust this or tighten this so it does catch or do I need a new QR and this one is worn out (its a 2008)
 

·
Registered
Joined
·
1,071 Posts
Grease the o-ring on the axle near the lever. You will be able to get the axle much tighter and won't have to worry about it loosening up.
 
1 - 2 of 2 Posts
Top