I have a moots stem that has a few sharp edges where the bolts clamp together at the back. I'm wondering how to go about filing it down. Can I send it to someone who would do it well as I don't trust myself on an expensive bit of ti.
my suggestion would be to take some fairly fine sand paper to it lightly to see how well that removes the edge...and just round the corners take no more than nessecary...and don't leave any sharp bottomed scrathes on it...these will produce crackes over time
DMR (AME Apprentice)
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to Mountain Bike owners and enthusiasts. Come join the discussion about bike parts, components, deals, performance, modifications, classifieds, trails, troubleshooting, maintenance, and more!