[muffinman7]

I recently bought a marzocchi bomber dj for a dirt jumper. The spacing is 20x110. What kind of hubs/wheels can work with this? Can I run a 15x100 wheel or do I need to get different hub caps? Thanks

 

[driver bob]

A 20mm axle will not fit into a 15mm hub.

 

[muffinman7]

A 20mm axle will not fit into a 15mm hub.

Can I use a 15x100 wheel and put on different endcaps?

 

[Redlands R&C]

Can I use a 15x100 wheel and put on different endcaps?

Depends on the hub. I had older Hope ProII's that would switch between 9mmQR/15mm/20mm thru axle. But again, all hub dependent.

 

[the-one1]

20x110 boost or non boost. Yeah...they did that

 

[driven916]

Also because your new spacing is Boost (110mm) vs 100mm, there may be adjustments needed to make the brake rotor and caliper line up. For example, you may need to re-dish the wheel or purchase the appropriate spacer kit (if there is one for your hub).

 

[Reaperactual]

It will obviously be easier to stick with fitting a Boost hub/wheel.

I ordered a Boost (110x15mm) Hope wheel with Pro 4 hub. When it arrived it also included a 20mm end cap conversion kit in the box.

 

[dave_f]

If it's the current marzocchi bomber dj, it is set up for 20x110 non-boost. Marzocchi sells a conversion kit for 15x100 hubs for that fork. If you have a 15x100 wheel it may be cheaper to get 20x110 (non-boost) endcaps for it, if the hub is adaptable to that. Alternatively it should be fairly simple to source a cheap 26" non-boost 20x110 wheel.

I'm not aware of any DJ fork using boost spacing.