Mountain Bike Reviews Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
763 Posts
Discussion Starter · #1 ·
So I searched and searched, and I think I found answers to 90% of my questions, but I just want to verify that I'm on the right track.

I want to convert my Hope Pro II rear hub to a threaded 10mm axle from existing QR. So I figure I'll need one of these and I believe that this will work for an axle. Am I doing alright so far?

Now, for the tricky part: how do I actually convert this? My understanding thus far is that using two 5mm hex keys allows me to remove the QR adapters on the hub. Then just press in the new 10mm adapters, snap in the retention clips and tighen the 5mm keys. Slide in the 10mm through bolt and I'm done. Now what did I forget or get wrong?:p

Thanks for the assistance!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top