Mountain Bike Reviews Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
8,282 Posts
Discussion Starter · #1 ·
Almost loving this fork, but would like a bit less LSC and HSC damping.

Compared to my Z1 Coil, it's just a wee bit spikey feeling on the sharp-edged stuff.

Any options or ideas, other than a trip back to Cane Creek?

Thanks!
 

·
Registered
Joined
·
8,282 Posts
Discussion Starter · #3 ·
What did you end up doing? Did you get it sufficiently dialed? I’m a Push ACS3 user btw
I talked at length with Cane Creek, and went with their recommendo of a heavier spring. Success. I was too deep in the travel, too often.

But I'll still have them pull a little LSC and HSC out of the damper when I send it back for winter service, since I'm riding near-fully open on both.
 

·
Registered
Joined
·
303 Posts
I talked at length with Cane Creek, and went with their recommendo of a heavier spring. Success. I was too deep in the travel, too often.

But I'll still have them pull a little LSC and HSC out of the damper when I send it back for winter service, since I'm riding near-fully open on both.
Still riding this and liking it? For reference what was your weight that the stock spring was not heavy enough?
 

·
Registered
Joined
·
8,282 Posts
Discussion Starter · #5 ·
Still riding this and liking it? For reference what was your weight that the stock spring was not heavy enough?
I pulled it off to send back for some revalving and I've been staring at it on my workbench for a couple months. Lazy!

I'm 195 and the heavier spring worked better, but still too much compression damping for my tastes. I may have mentioned this earlier in the thread, but it doesn't measure up to a Z1 Coil in the plushness department.
 
1 - 5 of 5 Posts
Top