Mountain Bike Reviews Forum banner
1 - 4 of 4 Posts

58 Posts
Discussion Starter · #1 ·
I am trying to see if I need my head tube reamed or chased? (not sure of the process).

I measured the head tube I.D. at 33.5 and the cup at 34.08 (+/- .2mm).

So I see that the head tube is approx. .6mm smaller than the cup. Should I have this looked at or try to go ahead and press the cups in?

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.