Hardware question

Usually the o-rings, they fit inside of the washers on most shock hardware sets.

You can usually spot a small channel where the o-ring goes on the underside of the washer.

Yes upper mount on that setup. Isnt any channel on the washers or on the bushings (non shock side). The o rings are larger than the raised portion of the shock hole. The washers fit nicely against the bushings which would put the orings on the shock. Both ways seem like they could work but both are difficult to keep in place while mounting.

I'm not sure then, you may have to contact Marin...they don't have any exploded view diagrams on their web site that would show how the pieces go together there.

Yeah i emailed them asking for one. Not much technical info. Thanks for the help