Mountain Bike Reviews Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Ok guys. Not ten minutes into my first fork overhaul and it's already not going as planned.
It's a 2002-ish Judy TT. Coil sprung. I removed the right top cap, looked down, and there appears to be no oil. not sure if that's good or bad. I tried to remove the left top cap, the one w/preload nob, but after minutes of twisting it still wont come out and feels like it's under pressure. Next, I went to the bottom bolts. I twisted these for a while but they didn't come out. I did the hammer thing and tried to remove the lowers but they feel like they're attached to a spring. Forgive me for my noobness but my fork is really sticky. I just want to change the oil!
 

·
B A N N E D
Joined
·
5,378 Posts
afehrenb said:
could you elaborate on how to pull this fork apart?
Look through the sticky thread at the top of the page called Service Information and Set-Up and you might find a service manual for your fork.
 
1 - 6 of 6 Posts
Top