Mountain Bike Reviews Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
Hi all.

Im a bit stuck first time doing oil change on my Diamond fork.
On the airspring thers an sticker saying its set at 150mm and I have opened up to change the travel to 160mm. However thers no spacer to find inside as shown in the DVO service video.
The sticker says YM16.

Hardwood Nail Cameras & optics Chain Steel


Cylinder Material property Engineering Metalworking hand tool Steel


Bicycle accessory Bicycle part Carbon Suspension part Cable


The fork have performed very good on my Tantrum Meltdown. But I would really like to try the 160mm travel setting, and will also remove some shim for less HSC dampening as ive been useing it in the softest setting for over a year, and have had some hand fatigue issiues on roughest steep enduro sections even setting the suspension setup with a Shockwiz.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top