Mountain Bike Reviews Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
347 Posts
Discussion Starter · #1 ·
I was trying to install the new floating style Hope rotor on my MM3 fork Thursday and found a clearance problem with the bolts against the fork. Has anyone encountered this before and what solutions were used. I am using a CK ISO hub also

thnaks
 

·
Let's ride
Joined
·
7,125 Posts
i just measured my Hope rotors. The 2 piece alu rotors are 4mm thick at the mount, the SS hope rotors are 2mm.
When my 180mm 2piece is mounted on my fox fork, there is only 2mm between the fork and the rotor bolts. Very tight.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top