Mountain Bike Reviews Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Good morning all

I have a Giant tough road sr2, I don't use the two smaller gears in the from just the biggest and have not had a reason to use the smaller one.
The crank set is a Shimano FC-MT210, 22/32/44, I was thinking of just
installing a single 44 tooth gear, What do you guys think
and can you use the same crank and just swap out to a single gear?

Thanks for your ideas and help
 

·
Registered
Joined
·
6,495 Posts
Just take the chain, put it on the big ring, take off the front shifter/derailleur.
I'm not sure if the other rings are removable - they may be stamped on. At some point, you could replace the crank, if the cross chaining is too much..
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top