Mountain Bike Reviews Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
129 Posts
Nater said:
I don't think you'll have any trouble. Pick up one of these and you should be ready to go...

QBP part #BR7151

Fits an M8 seatpost binder bolt.
Except that the binder bolt isn't in the rear on Inbreds. The seat tube "slot" faces forward.
 

·
Registered
Joined
·
123 Posts
p0werp0p said:
Except that the binder bolt isn't in the rear on Inbreds. The seat tube "slot" faces forward.
Get the QBP part and just rotate the seat clamp so the bolt is in the rear. The binder bolt does not have to face the same direction as the slot.:thumbsup:
 

·
Registered
Joined
·
998 Posts
Discussion Starter · #7 ·
Sounds good. Anyone tried cantis on the back of an Inbred? - will be keeping disk on the front, just fancy the mud clearance (and look) of the canti on the back - or am I being unnecessarily 'retro'?
 

·
Registered
Joined
·
2,044 Posts
So make another small slot at the back to have the hanger nestle in (as otherwise it will hit the seat tube, it actually needs a slot to sit in. Cutting a small slot will not affect the frame.
They also make hangers that mount on the outsides of the binder bolt. They are Y shaped. Then you don't need to cut the slot.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top