Mountain Bike Reviews Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a Trek Roscoe 7 2020. The rear hub is absolute garbage and Trek took ages to respond to my warranty claim. Finally they did and through my local shop they would send me a replacement wheel. This wheel would be the same as the stock one, so only fixing my issues temporarily. However they sent the wrong wheel; namely the Bontrager Line pro 40 rear wheel. The shop told be it wouldn't fit my frame, though I had heard some hubs, for example DT swiss 350 could be converted from boost 148 to boost 141 using QR end caps. I did some research and found the same kind of end caps compatible with the Bontrager Line Pro 40's hub on Trek's website. The items I found are W527033 and W562022. To be sure and use your knowledge; will these fit on the wheel I was talking about and will buying these two parts convert the hub to Boost 141 QR and thus fit my Roscoe? Thanks in advance :)

Trek sent me a rear wheel which is probably more expensive than my frame lol.
 

·
....
Joined
·
21 Posts
Those are the correct end caps to convert the Rapid Drive hubs to fit the Roscoe. In fact, I have a pair still in the bag sitting on my workbench that I ordered a few months ago before I sold my Roscoe...I intended to order a Line Comp 40 whel, but sold the bike before I did. PM me if interested...looking to get 1/2 the cost as listed on Trek's website.


https://www.trekbikes.com/us/en_US/...n-drive-axle-end-cap/p/31642/?colorCode=black

https://www.trekbikes.com/us/en_US/...ve-side-axle-end-cap/p/21955/?colorCode=black
 
1 - 2 of 2 Posts
Top