Mountain Bike Reviews Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Hello all,
I have recently purchased a used tracer 29 frame. It's a bit of a gamble as i have never ridden a 29er! Anyway, I don't have any information regarding bolt torque settings so if anyone can help it would be appreciated.
Also, is there a procedure for greasing the bearings or is it just a case of pumping it in. Don't know if the idea is to 'flush' old grease out by loosening the outer bearing caps.
Thanks in advance.:thumbsup:
 

·
Registered
Joined
·
1,328 Posts
MattZo, did you get the torques? If not, PM me and I'll send you the Intense "all bikes" manual that doesn't seem to be online anymore.
 

·
Registered
Joined
·
1,328 Posts
Oh, and as for the grease: Don't loosen anything, just pump grease into the zerk fittings until you see fresh grease oozing out at the links. At least that's what I've learned as of late - I need to start doing that on mine, as I've just installed new bearings since the old ones were shot.
 
1 - 4 of 4 Posts
Top