Mountain Bike Reviews Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Need some new forks, quite fancy Marzocchi s'coil 100mm and Fox float 100mm,
Will the Marz at 485 A/C be to long and affect the geometry i believe the floats are 465 A/C
LBS says no but he has them to sell,and i notice most ASR riders use the floats
Not sure on durability on the fox tho!
Cheers :)
 

·
shaved yeti
Joined
·
430 Posts
100mm Marz

I think it really depends on what you're using this bike for. The 100mm float works great. I built a koko (same geometries) with a talas the other day. Rode it around for a while I didn't really like the feel past 100mm. At 130mm it was pretty hard to pedal mild uphills because the ht angle is slacked too much, but was crazy fun riding down hill.

the frame is designed for 70mm to 100mm travel forks.

Not sure what the AC measurements are, but hope this helps.
 

·
Registered
Joined
·
790 Posts
Fox Float 100 RLT '05

Get the new Fox Float 100 RLT, the "05 model is available now. It is significantly lighter than the previous model and all reports are that the damping (which was already very good) has been significantly improved. The Fox Forxs also feature lower axle to crown heights than most and will keep your ASR steering precisely.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top