Mountain Bike Reviews Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
617 Posts
Discussion Starter · #1 ·
I picked up a pair of American Classic hubs off ebay. The seller said the front hub bearings were rough so I put in a new pair of bearings and they are pretty rough, not as smooth as they should be. The bearings went in one side with just thumb pressure and the other side I had to tap in with a hammer, but not that hard. The wheel rolls nice but you can feel that the bearing is rough. The bearing is a chinese ceramic bearing. The axle is not beat up at all. The hub was just rebuilt on new Stans ZTR rim. I was just going to ride them for a bit to see if they will seat in or whatever.
Any ideas?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top