Mountain Bike Reviews Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
Planning to get a VP Free frame to replace my 03 Heckler, however have some questions on transfer of parts.
Can I move my current crank, a Truvativ Holzfeller 22/32 teeth with 73/113mm Gigapipe Team DH BB over to the VP Free?
I'm guessing my Hope M4 Discs 180mm front/170mm rear should not be a problem though.

Any comments and insights would be much appreciated.
 

·
Registered
Joined
·
1,599 Posts
jackcfk said:
Planning to get a VP Free frame to replace my 03 Heckler, however have some questions on transfer of parts.
Can I move my current crank, a Truvativ Holzfeller 22/32 teeth with 73/113mm Gigapipe Team DH BB over to the VP Free?
I'm guessing my Hope M4 Discs 180mm front/170mm rear should not be a problem though.

Any comments and insights would be much appreciated.
The Holzfellers will be fine, but you will need a new BB-73x128. Also, the rear spacing is 150mmx12mm through-axle and your Heckler is 135mmx10mm.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top