Mountain Bike Reviews Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
230 Posts
Best way is .
Remove all air ..
Check wear the shock gets fully compress .
If you have the shaft clean can use a river band and tie it up .
The fully extend and measure to the rubber band ( may need to put some air in )
After that calculate 30%
Then put 100 or so psi and cycle the shock and adjust until you hit the desire measure ;)

Sent from my ONEPLUS A5000 using Tapatalk
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top