Extralite UltraDisc Wheelset

1.5/5 (2 Reviews)
Weight : 1320 grams


Product Description

  • Hubs: Extralite UltraHubs SPD
  • Spokes: straight putt black bladed,double butted 28+28
  • Rims: W24mm x h17mm, eyelet, offset "disc-only"
  • Graphics: laser etched


Review Options:  Sorted by Latest Review | Sort by Best Rating

Reviews 1 - 2 (2 Reviews Total)

User Reviews

Overall Rating:1
Value Rating:1
Submitted by Andrew a Cross Country Rider from Germany

Date Reviewed: June 27, 2008

Strengths:    Light

Weaknesses:    Poor quality bearings, dangerous freewheel ratchet system, soft metal freewheel body, not servicable.

Bottom Line:   
Bearings in front wheel have failed twice now. Not servicable and had to be shipped back to the factory in Italy at my cost. No explination of problem given and bearings still feel gritty.

Freewheel (ratchet system) is a complete joke. The 3 teeth within the freewheel were held in place by a very thin rubber band. It's obvious this was going to fail. Also I kept getting a banging noise from the freewheel. I also complained about the softness of the metal where the block is slotted on.

When I sent both wheels back to the Factory in Italy. When returned there was little improvement in the front bearings and the complete freewheel ratchet system was replaced.

I immediately opened up the freewheel to find out what and why it was replaced and why it's now so incredibly noise. The have replaced the rubber band for some flimsy springs. My suspicion is they wont last long. After about 3 months use the feewheel started to freeze up and while downhilling the chain was being dragged forward between the frame and the rotating wheel. First time I realised I was doing about 50km/hr. That could have been very nasty.

Bottom line...a poorly quality, very expensive pair of wheels

Expand full review >>

Duration Product Used:   2 Years

Purchased At:   Direct from Extralit

Similar Products Used:   Mavic Crossmax, Custom built Hope/Mavic.

Bike Setup:   Extralite F1 v4 frameset, Pace RC39 forks, mostly all Extralite (but had to replace poor quality Extralite headset and chainsst/BB)

Overall Rating:2
Value Rating:3
Submitted by John Nobile a Racer from Fairfield, CT USA

Date Reviewed: October 26, 2007

Strengths:    Very light and strong enough (spoke, hub, & rim-wise) wheelset. The frontwheel is about the lightest available, and has survived thousands of miles of hard & fast x-country racing.

Weaknesses:    The freewheel failed after only about 500 miles of racing. It jammed in the engaged mode, so at least I could keep going and get to where I could order another wheel (I was way out in the middle of nowhere when it happened). The freewheel apparently has ony one cartridge bearing in it rather than two, so from an engineering standpoint, I don't see how you could ensure proper alignment of the freewheel with only one central support point. Not sure if this had anything to do with the failure. The manufacturer repaired the freewheel & hub under warrantee, but would not explain to me why it failed, nor comment on the single-bearing design. Also, the cassette was a looser than usual fit, and the threads for the cassette retaining nut (cog) were abnormally tight.

Bottom Line:   
These wheels are very light, reasonably strong, and also aero, and are therefore very fast, but I can not trust them again for another ultra-endurance race because of the premature freewheel failure. But I will still use them for the relatively short NORBA x-country races and recreational rides. I am 146 lbs, so keep this in mind regarding my assessment that they are "strong enough" (although much of the racing was done with an extra 15 lbs of gear on the bike).

Expand full review >>

Favorite Trail:   Great Divide

Duration Product Used:   6 months

Price Paid:    $1100.00

Purchased At:   light-bikes.com

Similar Products Used:   XT, XTR, DT Swiss, Mavic

Bike Setup:   Titus Racer-X Ti, XTR

Reviews 1 - 2 (2 Reviews Total)

Review Options:  Sorted by Latest Review | Sort by Best Rating


ExtraLite UltraDisc TNT wheelset (1220g)

Has anyone tried it? What are your impressions on it? Is it worth paying € 999 for? [URL="http://www.extralite.com/Products/UltraDisc%20tnt.htm"]http://www.extralite.com/Products/UltraDisc%20tnt.htm[/URL] [IMG]http://www.extralite.com/imagesbike/ultradisc%20tnt%20ant.jpg[/IMG][IMG]http://www ... Read More »

Extralite Ultradisc wheelset

Any opinion about this wheelset? I don´t have references.Read More »

Extralite Ultradisc TNT - 1229 g !!!!!!

Here are my new wheelset : Extralite Ultradisc TNT...they comes with an incredible 1229 g real weight (Stan flaps included!). Stan ZTR Olimpic rims, pillar betatitanium butted straight pull spokes and Ultrahubs... :D [URL=http://imageshack.us][IMG]http://img444.imageshack.us/img444/5117/tn ... Read More »

please help choosing spokes for ultradisc wheels

hi, I have a wheelset with extralite ultrahubs SPD 32 holes, stans ZTR355s, and I'm looking for new spokes (they came with heavy single butted 2mm spokes). I'm 185 lbs (85 kg), and riding XC. I'm currently thinking of three options: sapim CX-ray pillar ti marwi ti I can get the pillars for 4$ ... Read More »

ultradisc ceramic SNT wheelset

I saw an auction in ebay for a wheelset with extralite ultraHubs SPD and ztr 355 rims, but the seller didn't know the kind of the spokes, and the location was Hong-Kong; I managed to sell my crossmax sls, and decided to buy those - and won them for 560 $ (+60 $ shipping); they arrived after 2 weeks ... Read More »

Read More »



 

INTERBIKE

Contests





Interbike Featured Booths

Check out the hottest mountain bike products from these brands!



















See All Interbike Coverage - Click Here »

   

MTBR on Facebook