Product DescriptionThe Pin It is tough. A seatpost should be a no-nonsense, sturdy, and strong component where the only thing you have to worry about is if you have the thing set at the right height. Azonic created this seatpost with 6061 T6 forged aluminum to fit the bill. Perfect for freeride, all-mountain, and downhill endeavors.
There have been no reviews posted yet for this product. Be the first by clicking Submit a Review
Related Pin It Forum Posts
I have an Avid Elixir 3, and while I was trying to remove the pin that clamps onto the brake caliper and pads bolt, it snapped in half. I'd like to know if that pin is absolutely necessary. I know it's there just in case the bolt becomes loose, but how often does that happen as long as I tighten it ... Read More »
I've mentioned previously on a dedicated thread on the Giant sub-forum that I had the impression my bike wasn't tracking properly. Since it's a FS Anthem X I thought it could have anything to do with the rear triangle assembly but the guys that replied said there was nothing to align on rear tri ... Read More »
I have one of the earlier Hayes Mag levers with the pressed pin, not the hex bolt using the Allen wrench. I know that that you have to use a hammer and a punch pin to remove it. I know that there is a removal tool but its costly and would be only used once which is not worth buying it. I am plan ... Read More »
2010 BIDWELL BUMP, CHICO CA. XC/Super D RACE !!! PIN IT NORCAL !! RIDE OR DIE !! SEPTEMBER 18TH.. THE MOST TECH GNAR XC / SD RACE IN NORCAL.... LEGENDARY SUPER D RACE !! 20 MINUTES OF VOLCANIC ROCK SINGLE TRACK !! ROCK GARDENS , TIGHT , TWISTY , STEEP !!! BAD . IF YOU DON'T RACE. YOU SHO ... Read More »